Compliance Standards

BIS 516 (Part-6)

Details

Consist of a measuring apparatus incorporating a suitable dial gauge reading accurately to 0.001 mm. This gauge will be rigidly mounted in a measuring Frame and will have a recessed end which can be located upon a 6.5 mm diameter ball or other reference point cemented in the specimen. The other end of the frame will have a similar recessed seating which can be located upon a second ball or reference point in the specimen. An invar steel rod of a suitable length with 6.5 mm diameter steel ball or hemispherical ends can be used as a standard of length against which the readings of the gauge can be tested. The apparatus will be designed to test Mould of 75mm x 75mm x 300mm long concrete specimen. 

Note

Mould for casting concrete specimen of 75 x 75 x 300, Gauge stud, Length gauge, Tamping bar, Tamping rod, Vibrating Table, Rubber Mallet, weighing balance and drying Oven necessary for the test are available at extra cost from us